I received from service provider ONE Access 1424 device for new 200 lines , i want to connect
this device to working network . I have 2801 gateway and CUCM 6.1 server connected to Multilayer switch
4500 series .
Please i need the steps or links to connect this device .
Best Regards ,
The configuration for this device it is from service provider . But how can i connect this device to
the voice gateway 2801 and CUCM 6.1 , and what the configuration can i configure in voice gateway
and CUCM 6.1. Service provider give the device with SIP trunk configuration .
unsure what that 1424 device is, but you will have to work with your provider to build either:
a-a SIP Trunk from CUCM to the 1424
b:a SIP dial peer from your Cisco 2800 to the 1424 (and subsequently a pattern from your CUCM to your 2800)
I assume your provider gave you details on how to configure it in terms of authentication and IP address?!
Please can you tell me the steps for basic SIP thrunk configuration on to
the 2801 router and CUCM 6.1 .
or any links for this . Thanks