07-18-2018 04:13 AM - edited 03-17-2019 01:13 PM
We have new installation for PRI line. we have ISR4321 router and NIM-2MFT-T1/E1 - T1/E1 Serial Module with PVDM 64 installed.
Router#sho inventory
NAME: "Chassis", DESCR: "Cisco ISR4321 Chassis"
PID: ISR4321/K9 , VID: V04, SN: FDO2225A2QT
NAME: "Power Supply Module 0", DESCR: "110W AC Power Supply for Cisco ISR 4320"
PID: PWR-4320-AC , VID: , SN:
NAME: "Fan Tray", DESCR: "Cisco ISR4320 Fan Assembly"
PID: ACS-4320-FANASSY , VID: , SN:
NAME: "module 0", DESCR: "Cisco ISR4321 Built-In NIM controller"
PID: ISR4321/K9 , VID: , SN:
NAME: "NIM subslot 0/2", DESCR: "NIM-2MFT-T1/E1 - T1/E1 Serial Module"
PID: NIM-2MFT-T1/E1 , VID: V05, SN: FOC222339CG
NAME: "subslot 0/2 db module 0", DESCR: "PVDM4-64 Voice DSP Module"
PID: PVDM4-64 , VID: V02, SN: FOC222314YE
NAME: "NIM subslot 0/0", DESCR: "Front Panel 2 ports Gigabitethernet Module"
PID: ISR4321-2x1GE , VID: V01, SN: JAB092709EL
NAME: "module R0", DESCR: "Cisco ISR4321 Route Processor"
PID: ISR4321/K9 , VID: V04, SN: FDO22241V8Y
NAME: "module F0", DESCR: "Cisco ISR4321 Forwarding Processor"
PID: ISR4321/K9 , VID: , SN:
While configuring on router how we will determine card type e1 command? ie slot and subslot?
can some body explain it? from the above inventory how will i determine slot and subslot?
07-18-2018 04:39 AM
yes i got it.
NAME: "NIM subslot 0/2", DESCR: "NIM-2MFT-T1/E1 - T1/E1 Serial Module"
PID: NIM-2MFT-T1/E1 , VID: V05, SN: FOC222339CG
this is what we need to check
so command will be
card type e1 0 2
07-18-2018 05:40 AM
That is correct.
07-18-2018 05:42 AM
Hi,
you can also refer the below link with Table 1.6 for details
regds,
aman
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide