No dial tone with VIC3-2FXS/DID on cisco 2901

[paolonova]

Hi all,

I am trying to connect an analogue phone to my Cisco router through a VIC3-2FXS card plugged on slot 3. Router runs Version 15.4(3)M3, RELEASE SOFTWARE (fc2). 

I have tried a couple of different phones but I cannot get any dial tone.

Here my conf 

#sh run 
voice-port 0/3/0
 ring cadence pattern01
 cptone GB
 caller-id enable

dial-peer voice 1001 pots
 destination-pattern 1001
 fax rate disable
 port 0/3/0

#sh voice port sum
                                           IN       OUT
PORT            CH   SIG-TYPE   ADMIN OPER STATUS   STATUS   EC
=============== == ============ ===== ==== ======== ======== ==
0/0/0           1   bri-voice   up    dorm none     none     y
0/0/0           2   bri-voice   up    dorm none     none     y
0/0/1           1   bri-voice   up    dorm none     none     y
0/0/1           2   bri-voice   up    dorm none     none     y
0/3/0           --  fxs-ls      up    dorm on-hook  idle     y
0/3/1           --  fxs-ls      up    dorm on-hook  idle     y

Any idea?

Thank you very much

[Roger Kallberg]

Hi,

Are you sure that the pin out on the phones match the FXS ports?

For more information about this see this url, http://www.cisco.com/c/en/us/support/docs/voice/analog-signaling-e-m-did-fxs-fxo/7938-2fxs-vic.html#info