Hi all,
I am trying to connect an analogue phone to my Cisco router through a VIC3-2FXS card plugged on slot 3. Router runs Version 15.4(3)M3, RELEASE SOFTWARE (fc2).
I have tried a couple of different phones but I cannot get any dial tone.
Here my conf
#sh run
voice-port 0/3/0
ring cadence pattern01
cptone GB
caller-id enable
dial-peer voice 1001 pots
destination-pattern 1001
fax rate disable
port 0/3/0
#sh voice port sum
IN OUT
PORT CH SIG-TYPE ADMIN OPER STATUS STATUS EC
=============== == ============ ===== ==== ======== ======== ==
0/0/0 1 bri-voice up dorm none none y
0/0/0 2 bri-voice up dorm none none y
0/0/1 1 bri-voice up dorm none none y
0/0/1 2 bri-voice up dorm none none y
0/3/0 -- fxs-ls up dorm on-hook idle y
0/3/1 -- fxs-ls up dorm on-hook idle y
Any idea?
Thank you very much