cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
418
Views
0
Helpful
1
Replies

no QOS stats on CMR/CDR

hjacquemin
Beginner
Beginner

Hi everyone,

I have a p roblem for the moment regarding QOS issue and I would collect logs with QOS stats inside. I checked on the CMR/CDR the the field is "null".

I found this old topic:

https://supportforums.cisco.com/message/1116927#1116927

I check my parameters and all seems ok.

If someone has an idea.

Thanks,

Hervé Jacquemin

1 Reply 1

William Bell
Advisor
Advisor

Hervé,

The service parameters you need to configure are:

CDR Enabled Flag: True

Call Diagnostics Enabled: Enabled Only When CDR Enabled Flag is True

It sounds you may have done this. What may be tripping you up is that the CDR Enabled Flag service parameter values are not a cluster wide parameter and you must configure each Communications Manager node individually . You only need to enable this flag on CUCM nodes which run the Call Manager service (aka call processing nodes).

So, under Service Parameters, go to the Call Manager service on each CUCM node in your cluster and toggle CDR Enabled Flag.

HTH.

Regards,

Bill

Please rate helpful posts.

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: