Per call load sharing on CUBE

[KY_]

Hi Dear,

I have a question about  CUBE, How can I load sharing with per call on CUBE

For example I have two dial  peer different session target I want to route to one calls different ISP one call  another ISP... (First call call should be route ISP A the second call should be route ISP B )

How can proceed it ?

Thanks

[Manish Gogna]

Hi Kemal,

Please check the following post with similar query 

https://supportforums.cisco.com/discussion/10644386/voip-dial-peer-load-balancing

HTH

Manish

[KY_]

Hi Manish

ı checked it before but its not answer my question.

I want to do this ,

First cal should be  route ISP a, second call should be ISP B and third one is come back again ISP and A  another one  shoul be route  ISP B.

That mean every one call should be match one by one different ISP.

If i use without preference command it will ve select randomly do it.

Thanks

[Manish Gogna]

That is correct, in this case the dialpeer selection would be random.

But you can add the below command.

dial-peer hunt 1

Which means <<1 - Longest match in phone number, explicit preference, least recent use>>

After this, the calls will match the two dial peers alternately.

So for your current requirement you can do the following.

1. Remove preference commands from both dial peers
2. And then add the dial-peer hunt 1, this should make the call to match both dial peers alternately

You may test this and let us know if it works.

Manish

[KY_]

In my scenerio , what should it do ?

Is following configuration correct ? Firs cal should be match dp 2 second call should match dp 3

I checked that but dial-peer hunt is different thing as my question.

http://www.cisco.com/en/US/docs/ios/12_3/vvf_r/vrg_d1_ps1839_TSD_Products_Command_Reference_Chapter.html#wp1100737

dial-peer voice 2 voip
 destination-pattern 55555
 session protocol sipv2
 session target ipv4:2.2.2.2
 voice-class codec 2 
 dtmf-relay rtp-nte


dial-peer voice 3 voip
  destination-pattern 55555
 session protocol sipv2
 session target ipv4:1.1.1.1
 voice-class codec 1  
 dtmf-relay rtp-nte

[igor_ye]

Hi Kemal

You can do this with voice class server-group with round-robin hunt scheme.

For example

!
voice class server-group 1
 ipv4 <ip ISP A> preference 1
 ipv4 <ip ISP B> preference 2

 hunt-scheme round-robin
!

dial-peer voice 2 voip
 destination-pattern 55555
 session protocol sipv2
 session server-group 1
 voice-class codec 2 
 dtmf-relay rtp-nte

http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/dialpeer/configuration/15-mt/vd-15-mt-book/multiple-outBound-dial-peer.html