03-04-2010 11:06 AM - edited 03-15-2019 09:38 PM
Hi!
Does any one has a sample config for PLAR on a VG224?
I have followed this guide,but suspect I need some config in the VG as well,
03-04-2010 11:14 AM
Hi
Are you running H.323 or MGCP on your VG?
Aaron
03-04-2010 11:17 AM
Hi! It is H323. regards Annika
03-04-2010 11:27 AM
Hi
THe document you saw really refers to MGCP, where all the dial plan stuff is controlled by CCM.
As you are H.323, you need to enter this command on the voice-port :
connection plar xxxx
Where xxxx is the number you want to dial.
Regards
Aaron
Please rate helpful posts...
03-04-2010 11:58 AM
Sorry I was totally wrong. The VG224 is set up in SCCP-mode. Not H323 as I wrote before.
03-30-2011 06:48 AM
No additional configuration needs to be performed on the VG224 assuming the VG224 is working properly otherwise.
If you follow the Cisco instructions and are having issues, you may need to add the partition of the destination DN to the calling search space, not just the newly created autodial partition.
Hope that helps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide