10-31-2010 03:32 PM - edited 03-16-2019 01:39 AM
Is there a Cisco access switch feature to disable a switchport if a device is attached directly to the port and it is not a Cisco phone?
Solved! Go to Solution.
10-31-2010 03:40 PM
10-31-2010 03:40 PM
10-31-2010 03:57 PM
How? Can you give an example?
10-31-2010 04:04 PM
Here's a good explanation about AutoSmartPort:
11-01-2010 02:46 AM
Hello,
you want to disbale from POE power that it is giivng when plug up ip phone
if you are plugging nay non ip phone device, for saving part use the commands:
under switch interface:
#int fa 0
# no poe power
exit
please check the commands for this aprt under interface.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide