10-21-2015 09:29 AM - edited 03-17-2019 04:38 AM
Hi
Trying to install and configure GB numbering plan. I am using dp-ffr.3-1-14.GB.cop.sgn (I did just spot that 3-1-15 is now out, but it should not matter. I have BE6K with CUCM 10.5.2. I uploaded the installer fine onto both publisher and the one subscriber that we have OK. I rebooted the cluster (pub then the sub), but when I go to add or modify a route pattern I only see NANP. I double checked the installed upgrades as follows........
Publisher
admin:show version active
Active Master Version: 10.5.2.10000-5
Active Version Installed Software Options:
cm-locale-en_GB-10.5.2.2000-1.cop
cmterm-ata190.1-2-1-004.k3.cop
dp-ffr.3-1-14.GB.cop
cm-locale-combined_network-10.5.2.2000-1.cop
ciscocm.platform-install-pwreset-v1.1.cop
Subscriber
admin:show version active
Active Master Version: 10.5.2.10000-5
Active Version Installed Software Options:
cm-locale-combined_network-10.5.2.2000-1.cop
dp-ffr.3-1-14.GB.cop
cmterm-ata190.1-2-1-004.k3.cop
cm-locale-en_GB-10.5.2.2000-1.cop
After several (I don't know what else to do) reboots - still no joy. Has anyone seen this?
Thanks
Brian
Solved! Go to Solution.
10-22-2015 02:53 AM
Can you post a screen shot from call routing>dial plan installer..similar to the one below
10-21-2015 10:50 AM
Have you installed the dial plan via cucm gui. You
need to install it for you to use it.
10-22-2015 01:19 AM
Yes
10-22-2015 02:53 AM
Can you post a screen shot from call routing>dial plan installer..similar to the one below
10-22-2015 04:16 AM
Sigh
I was 100% sure that I had installed it here - but when I went to get the screen shot, I saw that version numbers were blank.........
Installed it - and it's fine now thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide