R2 not sending DTMF

[opnineopnine]

Hi all

I have a E1 configured as R2, and when I do an outgoing call to any number I dont see the phone number that is calling.

I only see Private Number.

Thanks. 

[Leonardo Santana]

Hello,

Check on CUCM under route pattern config if Calling Line ID Presentation is restricted.

See the debugs if you are sending the ANI using the debug voice ccap inout

Use this link to see how to collect properly the debugs on a Cisco router.

https://supportforums.cisco.com/document/62906/how-properly-and-safely-collect-debugs-ios-router

Regards

Leonardo Santana