cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

829
Views
13
Helpful
3
Replies
Enthusiast

Replication fails between servers : CUCM 7.1.5.20000-6

Hi,

I had 7 CUCM servers on my cluster. dprelication fails between those servers.

I stop dbreplication on all subscribers and after that the publisher and i reset for all from pub and no change.

When i issue the "utils dbreplication runtimestate", the status hungs on value 0 for subscribers and value 3 on publisher with Setup requested / completd / in Progress message displayed in front of each subscriber server.

I repeated for many times to reset replication but it made ne sense.

Thanks and Best Regards

Driss

1 ACCEPTED SOLUTION

Accepted Solutions
Beginner

Replication fails between servers : CUCM 7.1.5.20000-6

Hi

Please go through the below mentioned link

https://supportforums.cisco.com/docs/DOC-13672

/Gagan

Please Rate useful Posts.

View solution in original post

3 REPLIES 3
Beginner

Replication fails between servers : CUCM 7.1.5.20000-6

Hi

Please go through the below mentioned link

https://supportforums.cisco.com/docs/DOC-13672

/Gagan

Please Rate useful Posts.

View solution in original post

Cisco Employee

Replication fails between servers : CUCM 7.1.5.20000-6

Can you pull the CM Database Status from Unified Reporting?

or Open a TAC Case!

Highlighted
Enthusiast

Replication fails between servers : CUCM 7.1.5.20000-6

Hi,

Problem is resolved.

Below are the steps followed :

  • utilis dbreplication stop (all subscribers)
  • utils dbreplication stop (publisher)
  • utils dbreplication reset (publisher)
  • restart publisher (until all services are started)
  • restart subscribers (one by one --->  mandatory until all sevices are started)
  • check by doing utils dbreplication runtimestate and get value 2 on replicate counter.

Thanks and Best Regards

Driss

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here