11-09-2010 03:55 PM - edited 03-16-2019 01:50 AM
Hi I have a CUCM 8.0.3.20000 with 2 h323 gateways, one with 3 E1 PRI and the other one with 1 E1 PRI, I have a route pattern that points first to the 3E1 gateway and then the other one.
In case that all E1s on the first gateway are full, the users are hearing "your call cannot be complete as dialed ....... "
Is This a normal behavior? can i changed this ?
Thanks a lot
Solved! Go to Solution.
11-09-2010 06:36 PM
We may need more information, but on initial reaction I would recommend looking at this global common on the IOS voice gateway.
"no dial-peer outbound status-check pots"
HTH.
Regards,
Bill
Please rate helpful posts.
Please remember to rate helpful responses and identify
11-09-2010 06:36 PM
We may need more information, but on initial reaction I would recommend looking at this global common on the IOS voice gateway.
"no dial-peer outbound status-check pots"
HTH.
Regards,
Bill
Please rate helpful posts.
Please remember to rate helpful responses and identify
11-10-2010 05:23 AM
Hi William
Many thanks for your answer, i gonna test it this afternoon, i will let you know.
Regards
FD
01-26-2011 11:16 AM
that command and change the ios was the solution, thanks a lot.
FD
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide