cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
949
Views
0
Helpful
4
Replies
lguyomard
Beginner

single number reach on cme - softkey mobility is not working

Hi,

I've cme 8.6 installed on a cisco router 2921, ipphone are 7942G and 7962G, I've configured SNR, but when i want to use the softkey mobility to activate and deactivate SNR I've an issue it does not work. Have you got any ideas ?

My ephone-template is like that :

ephone-template  1

url-button 4 snr

park reservation-group 2

service phone webAcess 0

transfer max-length 13

softkeys idle  Redial Cfwdall Pickup Newcall Join Dnd Mobility

softkeys connected  Hold Endcall Park RmLstC Select Trnsfer TrnsfVM Confrn ConfList Mobility Flash

after-hours exempt

codec g711alaw

ephone-dn  11  dual-line

number 130

label LOUBAT Sabine - 130

description LOUBAT Sabine

name LOUBAT Sabine

mobility

snr 0685220037 delay 4 timeout 15

call-forward busy 8888

call-forward noan 8888 timeout 15

mwi sip

ephone-template  1

url-button 4 snr

park reservation-group 2

service phone webAcess 0

transfer max-length 13

softkeys idle  Redial Cfwdall Pickup Newcall Join Dnd Mobility

softkeys connected  Hold Endcall Park RmLstC Select Trnsfer TrnsfVM Confrn ConfList Mobility Flash

after-hours exempt

codec g711alaw

the command mobility is added in ephone-dn

ephone-dn  11  dual-line
number 130
label TEST- 130
description TEST

name TEST

mobility
snr 06xxxxxxxx delay 4 timeout 15
call-forward busy 8888
call-forward noan 8888 timeout 15
mwi sip

Best regards,

Ludovic GUYOMARD

4 REPLIES 4
Hythim Ali El Hadad
Frequent Contributor

I think you have 2-points here

1- you should use cfwd-noan in the snr command that "call-forward noan" is restricted

2- I think your mwi will work without mwi-sip ,, if the above sol didn't help,, try removing also this mwi-sip

Regards

Hi

In fact the feature SNR is working but I'm unable to use the Mobility Soft key to activate or deactivate SNR on an IP PHONE 7942G/7962G.

How can I make the Mobility soft key operationnal ?

Best regards,

Certainly it is a fw bug

try to upgrade the IP Phone fw and check

Also I think the above 2-points need to check also

Regards

HI,

I know this is a old post.

Did you find any solution? I have the same problem with a Cisco 7965G. SNR is working, but the Mobility Softkey dosent work. Cannet activate or deactivate SNR.


Best Regards
Jonas

Content for Community-Ad

Spotlight Awards 2021