01-13-2019 01:43 PM - edited 03-17-2019 01:55 PM
01-13-2019 08:16 PM
This is happening because the incoming call arrives on the ISDN interface. This is not a VOIP interface. It is a POTS interface.
*Jan 13 21:01:01.366 UTC: %ISDN-6-DISCONNECT: Interface Serial0/2/0:21 disconnected from 977965787 , call lasted 14 seconds
Please change the dial-peer to "dial-peer voice 2 pots", or create a new dial-peer. This dial-peer will be matched after that.
01-14-2019 01:37 AM
01-14-2019 03:55 AM
Thanks Harris i will try that i can only test that over the weekend i will update the discussion board.
Could you point me somewhere where i can do some extensive reading and Labs on this technology will appreciate that so i get a deep understanding i feel need to refresh and be rock solid with the technology. much appreciated
01-14-2019 07:11 AM
I would suggest not deleting the "dial-peer voice 2 voip" as it may be in use for other things (such as outbound dialing) but rather creating a new "dial-peer voice 3 pots" to capture the inbound pots call. If you want to test without the dial-peer voice 2 voip, you can go into the dial-peer and issue "shutdown" on it. This will cause the router to ignore the dial-peer.
01-16-2019 06:16 AM
Thank you experts i will do just that, Please share some resources i can use to solidify my Quest for knowledge.
01-16-2019 06:38 AM
There is an ocean of documentation out there. Use Google to find what you are looking for at any particular moment.
Also, here is a link to Collaboration Training Videos that Cisco has published on a variety of topics. I have found the lengthy series of videos on SIP to be very educational!
Good luck in your studies. If you have more questions, we are here to help.
Maren
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide