cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1712
Views
0
Helpful
3
Replies

T1 Slip sec occuring in Voice Gateway.

bijoyjackjesse
Level 1
Level 1

Hello All,

I have my VG 28xx to have Slips occur in the T1 circuit(only 1 T1 for the site).

Below is the controller t1 output.

T1 0/0/0 is up.

Applique type is Channelized T1

Cablelength is long 0db

Description: PRI for Voice

No alarms detected.

alarm-trigger is not set

Soaking time: 3, Clearance time: 10

AIS State:Clear LOS State:Clear LOF State:Clear

Version info Firmware: 20100222, FPGA: 13, spm_count = 0

Framing is ESF, Line Code is B8ZS, Clock Source is Line.

CRC Threshold is 320. Reported from firmware is 320.

Data in current interval (620 seconds elapsed):

     0 Line Code Violations, 0 Path Code Violations

    103 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

     103 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs

Total Data (last 24 hours)

     0 Line Code Violations, 0 Path Code Violations,

     14412 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,

     14412 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs

Would using the cmd network-clock-select 1 T1 0/0/0 stop the Slip Secs and would configuring this bring a disruption of services.?

Thanks in advance for helping out.

Bijoy Jesse

1 Accepted Solution

Accepted Solutions

Aman Soi
VIP Alumni
VIP Alumni