Transferring calls and FXS Ports

[keanej]

Is there anyway for a handset on a FXS port to transfer a call ??

I appreciate that they do not have softkeys like 'call pickup' 'call park' 'transfer' 'conference'

Is there a way of using the keypad

- for example press '**4' to pickup or '**6' to transfer

Any help appreciated !

[paolo bevilacqua]

Configure FXS port for SCCP mode (described in documentation).

Register such port to CM or CME as if it was an ephone (also described in documentation) and assign it a DN.

You will be able to use flash for transfer and keypad sequences for other features.

[keanej]

So its possible ! Any pointers towards documentation - examples ?

[keanej]

I found this

http://www.cisco.com/en/US/docs/ios/voice/fxs/configuration/guide/fxssccpsplmft.html

looks like it hits the mark

[paolo bevilacqua]

Correct.

Please remember to rate useful posts clicking on the stars below.

[muratg7777 · Accepted solution]

I did the STCAPP config and registered my analog wireless phone but can not transfer or pick-up calls. When I press "R" button it closes the connection. I changed the timing hookflash-in values samething happenes. I can not use the fauture codes too.

telephony-service
!
fac standard

voice-port 0/0/3
timing hookflash-in 120

ephone-dn  73  dual-line
number 101 no-reg primary
pickup-group 1
label Tls
description PhoneA Analog
name Tls

ephone  14
device-security-mode none
mac-address DA2F.E68E.2003
max-calls-per-button 2
username "analog1"
type anl
button  1:73

!
stcapp ccm-group 1
stcapp
!
stcapp feature access-code
prefix *#
call forward all 2
call forward cancel 9
!
!
!
stcapp supplementary-services
port 0/0/3
  fallback-dn 101

UC_520#show stcapp device summary
Total Devices:           1
Total Calls in Progress: 0
Total Call Legs in Use:  0

Port       Device          Device   Call          Dev     Directory   Dev
Identifier Name            State    State         Type    Number      Cntl
---------- --------------- -------- ------------- ------- ----------- ----
0/0/3      AN1DA2FE68E2003 IS       IDLE           ALG     101        CME

UC_520#show stcapp feature codes

  stcapp feature access-code
    malicious call ID (MCID) ***
    prefix *#
    call forward all *#2
    call forward cancel *#9
    pickup local group *#3
    pickup different group *#4
    meetme-conference *#5
    pickup direct *#6
    forward-to-voicemail *#7
    cancel call waiting *#8

  stcapp feature speed-dial disabled

stcapp call-control mode is standard mode

and ideas what I am missing?

[paolo bevilacqua]

To be honest with you, having given you the exact information you needed, then been rated only "3" in return, that is not really the best incentive to further help.

[muratg7777]

Today I tried with different analog phone  and it worked, but it did not worked with wireless analog phone