trunkgroup fxo

[techguy]

Hi,

I have 2 analoge lines terminated on fxo ports. I have created on trunkgroup and it is called on each voice-port. Same trunkgroup is also called on all dial-peer. The problem is that if 1st line is busy its not selecting another line in trunkgroup. Any clue

[Ayodeji Okanlawon]

Try this..

trunk group SRSTPSTN (change this to your trunk group name)

max-retry 4

voice-class cause-code 34

hunt-scheme round-robin both down

Please rate all useful posts

"'Nature is too thin a screen, the glory of the omnipresent God bursts through it everywhere"-Ralph Waldo Emerson

[paolo bevilacqua]

Are you referring to incoming, or outgoing calls ?

[techguy]

@aokanlawon i will try and let you know.

@Paolo for outgoing calls

[paolo bevilacqua]

Update IOS. Re-hunting on member is supposed to happen with default configuration.

[Ayodeji Okanlawon]

Paolo,

I am running "2900-universalk9-mz.SPA.150-1.M4.bin" and I had to use that work around to make hunting happen. I had the same issue too. With E1 ISDN hunting happens automatically, but not on the fxo ports. I am not sure why..

Please rate all useful posts

"'Nature is too thin a screen, the glory of the omnipresent God bursts through it everywhere"-Ralph Waldo Emerson

[ciscovoiceguy]

Hi Paolo,

Connect only first FXO line and make a test call,if there is busy line directly connect analog phone and make a test call if not please check with Service Provider.

Thanks