05-05-2011 08:08 AM - edited 03-16-2019 04:49 AM
Hi, Friends.
I have a cluster of Unity 8.0 integrated with Call Manager 6.15. I have been identifying when telephony users will enter a voice mail to your phone the MWI is not on. Similarly when the messages are not heard the MWI is turned off. I have reviewed the settings and permissions and CSS phones are capable of reaching the MWI correctly.
For this I dialed from one of the IP Phone allow the numbers that activate and deactivate the MWI and the result has been positive.
05-05-2011 09:47 AM
Was this working before??
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
05-05-2011 12:11 PM
Ok, this platform was working from December 2010 and its having this behavior since last weekend. It seems that the signal that must be sent from the Unity to the Ip phones is not getting thru or it is not being sent.
Is it possible that there are some blocked ports or protocols so this is cutting off the communication?.
Thx,
05-05-2011 12:29 PM
That's SCCP son unless it's not taking any calls or ports are not registered I don't think it's a network issue.
Start by reviewing the config on both sides (CSS/partitions/MWI DNs) and in CUCM check for any overlapping or changes in the route plan that could cause this.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide