cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1341
Views
0
Helpful
5
Replies

VG224 IOS needed

vipankapur1
Level 1
Level 1

Hello,

Does anyone have a version of the VG224 IOS.  Mine has gone corroupt and I cannot download a new version from Cisco without a service contract.

This was the version that I was running.

vg224-i6s-mz.124-9.T7.bin

Now all I get is the following when starting my VG224:

Readonly ROMMON initialized

program load complete, entry point: 0x80008000, size: 0x1af1690

Error : compressed image checksum is incorrect 0x38D59F55

        Expected a checksum of 0x51B987C0

*** System received a Software forced crash ***

signal= 0x17, code= 0x5, context= 0x80021220

PC = 0x800080d4, Cause = 0x20, Status Reg = 0x3041e803

System Bootstrap, Version 12.4(13r)T7, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 2008 by cisco Systems, Inc.

FPGA readonly version:00250027

FPGA upgrade version :No upgrade FPGA version present

ReadOnly FPGA currently running

vg224 platform with 131072 Kbytes of main memory

Main memory is configured to 64 bit mode with parity disabled

Readonly ROMMON initialized

Entering rommon> prompt after several failed attempts to boot an IOS image.

Please check your internal/external flash drives for the correct IOS image

and issue 'reset' at the rommon> prompt to re-try the boot process.

rommon 1 >

I have tried the steps listed in the link below and it did not help.

http://www.cisco.com/en/US/products/hw/routers/ps359/products_tech_note09186a00800a750e.shtml

1 Accepted Solution

Accepted Solutions

Chris Deren
Hall of Fame
Hall of Fame

You will need to open a TAC case for such a request. This is like asking for free music or movies, there is a reason licenses and support is required.

HTH,

Chris

View solution in original post

5 Replies 5

Chris Deren
Hall of Fame
Hall of Fame

You will need to open a TAC case for such a request. This is like asking for free music or movies, there is a reason licenses and support is required.

HTH,

Chris

Chris,

Thank you for the response.  Do you know how I can format the flash card and install the ios image onto it so that it is reconized by the VG224 gateway.

You can simply delete the existing IOS by issueing "del slot1 XXXX" where XXX is the name of the file.

Chris

I am currently in ROMMON mode so I don't have an option to del.  I need to be able to format the flashcard and put an IOS image onto it.  This is what I see under ROMMON.

rommon 19 > dev

Devices in device table:

        id  name

    flash:  internal compact flash

    slot0:  external compact flash

    eprom:  eprom

rommon 20 > dir slot0:

device does not contain a valid magic number

dir: cannot open device "slot0:"

rommon 21 >

Had the same problem.  Solution: You need to get a working flash with the IOS image and place it into the slot that has the problem insert at rammon> confreg 0x2142

rammon2> reset

 

Either format the flash in FAT16 or get a Flash already formatted in Flash16

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: