Voice Gateway Configuration - Help

[shawnmic1]

Dear Support,

I am using CUCM 10 , Voice Gateway - 2921, protocol H.323

The problem is that when i am dialing an international call , i am unable to input an digits to select options.

International calling dial-peer

dial-peer voice 20 pots
description ##-International-Calls-##
tone ringback alert-no-PI
translation-profile outgoing OUT
destination-pattern 900T
direct-inward-dial
port 0/0/0:15
prefix 00
!

Note: with mobile dial-peer i am able to input digits.

Mobile dial-peer

dial-peer voice 1 pots
tone ringback alert-no-PI
translation-profile outgoing OUT
destination-pattern 905[0256].......
direct-inward-dial
port 0/0/0:15
forward-digits 10

I would appreciate if some one could help me solve this issue.

Thanks

[HARIS_HUSSAIN]

Replicate the Issue and collect the debugs

debug voip rtp session named-event

debug h245 asn1

Also Share you Complete Configuration , All the dial-peers.

We need to Verify What Was DTMF Method Negotiated.

Thanks

haris

[Chris Deren]

Also, post all of your dial-peers as each call has 2 legs thus 2 dial-peers, in your example first a voip dialpeer is matched and you need to have one with proper DTMF method, otherwise default dial-peer 0 is used.