cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
849
Views
0
Helpful
2
Replies
aleemuddin
Beginner

voice on 2801 with vic3-2fxs/did

hi,

I am trying to configure voice on 2801 with vic3-2fxs/did while IOS is 12.4(20)T

dail tone is available but when i dial number dail tone is still cont...no ring tone

voice-port 0/0/0
input gain 7
cptone BR
timeouts call-disconnect 5
timeouts wait-release 5
!
voice-port 0/0/1
input gain 7
cptone BR
timeouts call-disconnect 5
timeouts wait-release 5
!
dial-peer voice 410 pots
destination-pattern 410
port 0/0/0
!
dial-peer voice 411 pots
destination-pattern 411
port 0/0/1
!

*****

same configuration worked for me using vic2-2fxs with IOS 12.4(15)T or etc.,, now cisco replaced vic2-2fxs with vic3-2fxs/did and it will work only on IOS 12.4(15)ZX or 12.4(20)T. after upgrading IOS router can  see the voice card and i configured ports ..dail tone there but when dailing on number dail tone is not changing to ring tone..

pls advise.. Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Steven Holl
Cisco Employee

That should be all you need to get this to work.  Collect:

debug voip ccapi inout

debug vpm sig

And for kicks, try it with input gain at 0.

View solution in original post

2 REPLIES 2
Steven Holl
Cisco Employee

That should be all you need to get this to work.  Collect:

debug voip ccapi inout

debug vpm sig

And for kicks, try it with input gain at 0.

View solution in original post

Hi Steven,

Thanks for your support man..Input gain 0 worked.. thanks again.

regards,

Content for Community-Ad

Spotlight Awards 2021

This widget could not be displayed.