WIC-1DSU-T1 V2 Voice Compatibility

[victorcamacho]

Good Morning Gentlemen

We recently setup a CUCM that is working fine and while going through my hardware inventory I noticed that I had a cisco 2811 router with a WIC 1DSU-T1 V1 card on it, this router is not in use  and I will like to start using this, so my brilliant idea (brilliant to me at least) is to set up the 2811 router as a mgcp gateway on our CUCM and use the T1 card to connect to a NEC system that has a t1 interface on it, I'm assuming that I only need to add a PVDM2-32 voice dsp module to the 2811 router to be able to use voice on this, is my assumption about this correct? will the WIC-1DSU-T1 V2 support voice (full t1) or is this wic one of those that only support data...

Thank you all for your support!!!

[Rob Huffman · Accepted solution]

Hi Victor,

Sadly that module does not support voice T1/PRI;

"The T1 CSU/DSU WIC provides full or fractional T1 service. T1 CSU/DSU WIC does not do channelized T1 or ISDN Primary Rate Interface (PRI)."

From;

http://www.cisco.com/c/en/us/support/docs/interfaces-modules/1-port-t1-fractional-t1-dsu-csu-wan-interface-card/7255-wic-1dsu-t1.html

Cheers!

Rob

[victorcamacho]

Thank you Rob!!

[Rob Huffman]

Hi Victor,

You are most welcome my friend!

Cheers!

Rob