cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
271
Views
0
Helpful
1
Replies

Wireshark not display full to address for outbound calls

Hi,

 

We have CUCM 12.5

We are using remote span with wireshark for call recording

 

We noticed that the sip to address displays only the first digit as shown below

To: sip:9@10.10.10.10 [cucm-ip-address]

while the "from" field displays the calling number with no problem

 

So when calling from the ip phone [model 3905] the call recording displays the called number as 9 or 3 [only the first digit]

 

What could be the problem here

I think that sip digits sent inband and I have disabled G722 if it could help but didn't test it yet

Plz advise if could help

 

Thanks

 

1 Reply 1

Are you using any calling party translation ?

 

Try running  DNA and see the result.



Response Signature