Xmedius Fax Server Integration

[jkjackson]

I am in the process of integrating the Xmedius fax server and cannot seem to get the server to communicate with the call manager. We are running CCM 4.2.3 and i have followe the Xmedius install guide. The Xmedius installer technicians cant figure it out either. The fax server wont send a fax or answer an inbound fax call. We have configured it as MGCP and the fax server is setup in call manager as an H.323 gateway. Any assistance would be greatly apreciated.

[kinwai]

i got the following config working before but it's for h323

dial-peer voice 301 voip

description FAX Dial-Peer

destination-pattern 6431....

session target ipv4:10.205.x.x

dtmf-relay h245-signal

codec g711ulaw

fax rate 14400

fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback cisco

you might want to try it out

[jkjackson]

Thanks,

that didnt seem to help though.