Catalyst C9300 VPLS support

[maxmaeve]

Hello, cisco community.

I can't find any information about VPLS(H-VPLS) support in C9300.

We want to replace our ME3600X/ME3800X, but we're not sure if C9300 is suitable enough.

Could anyone help me with that?

[filopeter · Accepted solution]

Hello,

please check the latest MPLS configuration guide for Cat9300 if the supported features fit to your requirements.

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-12/configuration_guide/mpls/b_1612_mpls_9300_cg/configuring___ethernet_over_mpls__eompls__and_pseudowire_redundancy__pwr_.html

Please be aware that EFP configuration syntax is not supported and "xconnect on subinterface" support is supported only in the latest IOS XE Gibraltar 16.12.x

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-12/release_notes/ol-16-12-9300.html

Apart from these restrictions, H-VPLS can be configured. 

Best Regards,

P.

[maxmaeve]

Thank you!

[balaji.bandi · Accepted solution]

You can look below configuration guide :

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-8/configuration_guide/mpls/b_168_mpls_9300_cg/b_168_mpls_9300_cg_chapter_01000.html

[maxmaeve]

Thank you for your help!

[balaji.bandi]

Glad it was helpful, if this is what you looking for then please mark as resolved.