Network Access Control

Hello, We got two ACS in cluster mode. We tried to upgrad to 5.6  Before we started we did a backup using the  backup acs repository backups To both ACSs. The upgrade process failed for the secondary ACS and we needed to re-install the entire system...

I can't seem to work this one out... how do you match against an AD group at the authentication level (not authorisation) I have a wide AD group selected under the AD external identity sources (covering all corporate wireless users) I don't want thos...

I am attempting to set up AAA authentication to two Radius servers. When I run a test aaa group command I succeed in authenticating.  However when I attempt to login using SSH I cannot authenticate. I am attaching the pertinent config statements belo...

Anyone know what level of access a user might have if they get mapped to the root, All Groups?

Hi, I've Cisco ISE 2.1 on virtual machine. I've setup a self registered guest portal and I've selected the "Automatically registered guest devices" on the section named Guest Devices Registration Settings. After the successful login of a guest, I not...

hi, all Did anyone have experience in integrate Cisco ISE 2.0 and Ruckus ZD1100 ? we need to confirm if ZD1100 can integrate into ISE 2.x enviroment. the business goal is achieve BYOD need. thank you.

Could somebody please elaborate the differences between a per-user acl and a downloadable ACL (dacl) in plain english? I tried to find information about both in the cisco docs but I can't really find the key differences as both seem to be set in the ...

Hi All, I'm trying to enable all my AD users as sponsors in ISE. "AD_Users" is specified in "Identity source sequence" option of default Sponsor portal. But login still fails with "wrong username or password" message. "Sponsor Login and Audit" report...

I have an issue with applying a patch to an ACS 1121 appliance running version 5.2.0.26. I have 5 units that needed updating and the first one is the unit with the problem. The subsequent ones updated with no issues.When I do a show version the 5.2.0...

I have an ESXi 6.0 test host, upon which I am evaluating ISE 2.0. I have built two ISEs, in the same manner as I would (and which works fine every time) for ISE 1.3. The two servers are running as Primary/Secondary, on the same ESXi6.0 host as a Wind...

Trying to test an ISE EAP-PEAP auth policy with NTRadPing, but struggling to figure out how to pass the correct RADIUS attributes.  I believe I need the following Attribute Value Pairs:        AVP: l=12 t=User-Name(1): joeuser        AVP: l=18 t=User...