Network Access Control

Hello all, I`d like to put one question here. In our production we use EAP-TLS for wired 802.1x (using ACS for authentication), however we`re about to change for PEAP. Is there any way that these two can coexist together on ACS until we completely re...

I have configured a profiling policy based on CDP Cache Platform "contains" and "starts with" criteria and the policy never matches.  I've confirmed that the endpoint details actually contain the information I'm looking for, and an endpoint debug ref...

We just upgraded from 1.3 to 2.1. The upgrade was successful, but now I cannot log into ISE with my AD credentials. They worked fine before the upgrade, and my co-worker has no issue logging in with his AD credentials, so the AD backend is fine. I ha...

I am trying to limit traffic profiles to users via radius.I have found that in the documentation:Configuring Controller Settings - Configuring Quality of Service  [Cisco 5500 Series Wireless Controllers] - Cisco Syste…“If you choose to create an entr...

So I've read about 2 weeks of posts trying to figure this out and read multiple guides to no avail. So i'm hoping it's a stupid mistake. First here is my AP config.ap#sh runBuilding configuration...Current configuration : 1750 bytes!version 12.4no se...

Hi! We have installed ISE 2.1 for AAA process for VPN users at ASA5545x. Anyconnect  users authenticate successfully and we see username into RADIUS log at ISE. Also we have FirePower modules in ASA and virtual appliance FireSight 6.1 . How we can to...

Can anyone help me determine the configurable range for the polling interval for PAN auto failover?  The ISE 2.1 Admin Guide includes the following steps:Step 6    Provide the  Polling Interval time after which the Administration node status will be ...

Hi, I have 2 x ISE-VM-K9= licenses and i want to deploy ISE in an Standalone mode with HA. i.e have 2 boxes Node1 and Node2 each hosting all three personas and closely located in 1 data centre. then i want to have a third box node 3 in a remote data ...

Greetings, I am testing ISE2.0.1, but I'm having an issue that all devices profile as Apple-Devices. I put all the sub categories of Apple-Devices as their own category, and disabled Apple-Devices. This causes them to come on as unknown devices. It s...