Network Access Control

Hello!First, my configuration, (then the problem down below):I have an Aironet 1142 with mulitple SSIDs [mapped to VLANs] connected to Gi1/0/2 on a 2960 switch in a user-accessible area.  This switch is uplinked to another 2960 switch in a wiring clo...

During an upgrade to 1.1.4, one of the Policy nodes didn't deregister successfully. The Primary shows it as now a standalone, but it seems to still be a part of the distributed deployment. I upgraded the Policy node and the rest of the nodes. I tried...

Hi all, just a quick note I wanted to point out for any of the AAA admin folks currently using Active Directory for their external identity store.I'd like to preface this post by saying that I strongly recommend that you purchase the SAS option for y...

after install ACS 5.2.... i tried http://direccionACS/acsadmin couldnt get ti...when i enter the show application status acs command, get:     management   running(http is nonresponsive)how could i fix it?????  i dont have access to the web interface

I am currently trying to configure FWSM to have two factor authentication using RSA. I have configured the ACS and RSA server and everything is ok for routers and switches. What do I need to configure on the firewall side. I have pointed the authenti...

Dear Expert,Im a newbie and ACS and i would like to know how to enable the "Configuration Audit" for someone login to my network devices using their ACS login and i can monitor what they did on it.Appreciate if you could give me a simple steps .. tha...

I'm new to ACS 5.4 and have very limited knowledge of the previous versions. I am trying to get users in the external identity store (AD) to be dropped directly into enable mode after being authenticated, since I don't know of a way to set an enable ...

Good morning,I have configured my switch and ISE with this templatehttps://supportforums.cisco.com/docs/DOC-18325But i want the portal to second interface, if i change the advance attributes with the address https://ip(second interface):8443/guestpor...

First of all, I've to say that I'm totally new at the certificates' world.My customer has a wireless network working properly, with supplicants using certificates and authenticating against a Juniper RADIUS server. Now we need to replace the Juniper ...

Hi,I have ISE running ver 1.1.1.268. We limited access certain services before authuenticate with ACL-DEFAULT(given below) as per the Trustsec desgin guide.Now the issue is that when you have ACL-DEFAULT on the port NAC agent doest not pop-up and doe...

Hi,I have two ise 1.1.2 with these roles:Admin Primary / Monitor SecondaryAdmin Secondary/ Monitor PrimaryI have bought a godaddy cert for EAP authentication and all works well, but when my primray goes down for some reason and all authentications ar...

I'm thinking this is possible, but I just can't figure out how to set it up.Obviously I can group devices together however I want, but can I apply an Identity Store Sequence to one group of devices, and a different sequence to another group of device...