Network Access Control

We have number of GPRS terminals, they work in our private APN. Can we assign static or dynamic IPs to them?Terminals work with IP, not with PPP. We have direct connect with ISP via serial interface. ISP forwards all Radius traffic to our ACS applian...

I have a very strange issue with wireless WebAuth where the users get redirected successfully to the WebAuth page and can enter their credentials, but once they accept the AUP they get redirected right back to the login page.  ISE 1.1 and WLC 7.0.235...

Hi all,I've been playing around with ISE demo and I am very impressed!!!After trying different scenarios with my co-workers I came to a point where we find it kind of buggy.I have rules to redirect unknown users to pasturing through web where they do...

I've recently upgraded from 5.2 to 5.3 and am running 5.3.0.40.4.I've just noticed a wierd issue where on the Internal User identity store I cannot see any users on the first page only, but if I go to any other page I see the users.  Changing the num...

Hi!First some background information. We use a combination of Cisco ACS and Cisco catalyst 3560 switches for network authentication and authorization. Clients (Windows XP) have a certificate installed which will grand access to the network and put th...

I was talking with a co-worker about multi-auth host mode and we are wondering how does it handle broadcast traffic. So if we have a switch port set to multi-auth and we are doing dynamic vlan assignment. Say you have an esx host device running 5 vm ...

Hello Community!I have a Cisco 4506 With IOS 12.2 54SG1Iam new on Acs 4.2 and i want to use Certificates to authenticate my windows XP Client and Igels.On Windows Xp i selected :IEEE 802.1X Authentication enable EAP (Peap)But i dont understand the Ce...

Hi All,I have setup a Cisco ASA with the device admin access to be authencticatedand authorizated with a Cisco ACS v 5.2. However, I am not able to exeute and command at the CLI even I have authenicated successfully. I have configure the Cisco ACS to...

I want to register Secondary ACS with Primary instance, but its show up following error  "This System Failure occured: server cannot be adde to the deploymnet. Server has sam License ID as server PrimaryACS that already exist in the deployment. Your ...

Hello, If I want to use 802.1X with PEAP,is it enough with the self-signed certificate that cames the ACS(for example for https)? Or I need other certificate in the ACS?Thanks in advanceRegards

Hi everybody!I want to know how to make the guest go through the web auth whereas people on an active directory (employees, staff) can just authenticate via their session login, with the SAME SSID for both.Thanks in advance,Ana Linda.

hi expertsi need your help regarding below I'm new in ISE , I configured the ISE to be integrated with the active directory , so any user want to login to the network should has username & password at the active directory . most of the users already...