Network Access Control

Hi,Can anybody route me to configuration example for command authorization in routers or switches or firewall for ACS 5.0.ORUSER-A should be placed in privilege level 2 and given access to all debug commands and the undebug all command.Assigned speci...

HiI have done my VPN user authentication with user database on AD via ACS. The version of ACS appliance is 4.2.1.15 on 1120 platform.All configuration done, but problem arises when user first time authenticates, I got message in ACS in failed attempt...

Good morning everybodyCurrently I have installed 2 ACS 5.x with one of them defined as primary. When checking the health status of the 2 devices via "Monitoring and Reports - Dashboard" I get an "Status not available" for the secondary device which o...

Hi,I want to authanticate to user on mysql. In my system ACS is Radius server and MySQL is the user database. I use the ODBC connector on ACS.When I configure ODBC authentication on ACS, take a error " DSN successfully connected. Driver reports proce...

Here is my problem. Why can I not log into the ACS server via ssh but I can log in to the gui interface on http?I get the username and password prompt without a problem but it will not accept my username and password.Any thoughts?Thanks

All,We are currently running ACS 3.3 on a Windows 2003 member server of our domain.  It has become necessary for the server administrators to upgrade our domain controllers from Windows 2003 to Windows 2008.  Since we have no interest of running ACS ...

Hi all,I have created a shell profile with a default Privilege level of 15, I am able to successfully call this via an Access Service Rule. The issue I have however is that depite having the # symbol after I log in, the switch will only allow me to p...

Hi all,We have and Cisco ACS v4.2 on a Cisco Appliance, and we need to integrate it with Active Directory. Can you help me??Thanks for your helpRegards!!!Rafael Turriago

Hi group,I'm configuring downloadable ACL on ACS 5.1 for authorized vpn users. Whenever users log in to vpn through ASA then they will get individual ACL.I checked AAA Protocol > RADIUS Authentication Report and found something like #ACSACL#-IP-testD...

i want the configuration steps that integrate ACS with LDAP , and i want to match the attributes of specific domain user "like sAMAccount" , and apply access control policy on this specific LDAP username .

Hello,Can someone help me, I have this error when I try to login on Redhat server :TacacsLoginFlow,22/11/2010,18:41:58:347,ERROR,3057433504,cntx=0003764282,sesn=EMEA-PAR-ACS01/78155693/561084,user=user-name,Failed to dispatch the T+ Authen Login pack...

Hi ...Just setup Cisco 7606 Router by console with IOS version s72033-advipservicesk9_wan-mz.122-33.SRA3.bin.username xxxx password 7 xxxxxxxxaaa new-modelaaa authentication login default group tacacs+ localaaa authentication enable default group tac...

Hi,I am using ACS V 4.1 .Under reports and activity when i try to check for TACACS+ administration report the report is getting generated but there is no data avaliable in the report.In the router side the AAA configuration is proper,Please help in t...

Basically for integration of the role based CLI to a particular user in 1800 aeries router is as follows.....(Conf )# username JAMES view SHOWMODE secret CISCObut when this command is run in 2800 series router this doesn't work so how can this be don...

Recently I'm using ACS 5.1 to support external RADIUS Servers, and read the manauls to process with the following workflow.Install Linux RADIUS Service (this part was tested)Install FreeRADIUS ServiceAdd new linux user account Cisco ACS 5.1Add Extern...