Network Access Control

i have configured the network device group and assigned some dummy entries of acs servers have been added. now what i exactly want is, i want to remove the unnecessary entries in NDG ans also which are added in "Not assigned group". because i am addi...

I am trying to get a WLC4404-100 to use a ACS Express 5.0 for authentication to the WLC for administration. I have the device in the ACs but it does not authenticate any users. If i switch to RADIUS on the WLC with Local as secondary in the priorit...

Hi,My ACS is integrated with AD(member of domain server) and ASA(8.2) is authenticating domain users via ACS successfully (by test aaa command) but my SSL vpn users are not able to authenticate with AD however ssl vpn user can authenticate with ACS u...

I'm new to IOS but I'm taking ICND 1 and ICND 2 to catch up. I've gone as far as configuring a 3560 switch from "scratch" in a test environment, and am in part one of ICND 2.Setting this switch up for HTTP administration, I've been prompted repeatedl...

Hi all,        I have Cisco ACS3.2 (windows) and had pix 6.3(4) and access vpn users were authenticating from ACS with radius protocol.I upgraded pix ios to 7.2(2), now access vpn users can authenticate till group and cannot authenticate user credent...

AllCurrently running 4 ACS 5.1 servers to load balance our 802.1x requests, but am getting an error message which is a bit unhelpful in terms of details.The error message is11051 RADIUS packet contains invalid state attributeand only seems to occur ...

Can someone give me some pointers on how to configure Cisco ACS to accept the enable password from a router using Radius rather than using the local enable password. Do I have to use the Radius attributes to achieve this? The AAA radius configuration...

Hello Dears,I m facing problem when i try to install the ACS 5.1 on VMware, It give me error COULD NOT FIND KERNEL IMAGE :LINUX when i try to boot from DVD ,it is a  Evaluation version download from Cisco.com Thanks

Hi,I ve got my clients authenticated through ACS and created two different command sets ,tested as well.Kindly advice how to backup Acs data as we are using two ciscoTACACS servers1113 one would work as fail over .

hi,have a win2008 radius server with my ASA and its working fine. Know i want a RSA token solution for clientless SSL VPN. Which tokens the asa supports and is there anywhere a guide how to implement this?end scenario:Clientless SSL VPN, Anyconnect l...

HiI'm having a problem to set the netmask für SVC (anyconnect) clients when using a static IP assignment from MSAD via LDAP.The schemata within MS AD has no netmask attribute.We assign a 10.x.x.x address in the MS AD Dial-Up tab.This results in that ...

Good afternoon,For remote vpn users, I would like to configure a dynamic vpn split tunnel depending where are they connected.For example if a remote user is connected to ASA from italy, auth via acs radius server, a split tunnel list will be applied ...

Hi All,I am needing to find away to monitor if a monitor sessions is created/deleted or change.Is there anyway that you know of to see that detail