Network Access Control

Hello -I am trying setup a command set for an identity group that will allow very specific commands on particular access switches.   Namely, sho conf, conf t, int fa0/1-x, speed x, duplex x, shut, no shut, end, wr mem, exit.I have created a identity ...

Hello again!As mentioned in another post here, I'm trying to set up both machine authentication and user authentication. But I'm puzzled by one of the Failure Reasons ACS gives me:Failure Reason : 12752 Failed to negotiate EAP for inner method becaus...

Hello,When I want to load a configuration file on my ACS 5.1 appliance, I see in my ftp server that the file is properly sent to the ACS server, but I get the error below and the configuration is not loaded. Any idea? ftp connection is fine.thx Karie...

It was working, but now it refuses to start.  A restart and a reboot have not helped. I think it stopped around the time I connected to and AD domain, which also requrired an ntp addition.  Appreciate any advice on where to start troubleshooting this...

Hi All,            We had that ACS VM server that was loosing PING from time to time, after a bunch of unsuccessful troubleshooting. We have decided to rebuild the vm machine and migrate ACS from backup to the new server.So the new server is built an...

We're attempting to perform an ACS restore on our ACS Server v3.2 running on a Windows 2003 server.Documentation says that the restore process should take several minutes, but we've tried this twice with no luck. The first time went all night (from 4...

Hey all,I have a new stand-alone ACS 5.2 install, and have setup an RSA Server under "RSA SecureID Token Servers", and have imported the sdconf file.On the RSA side, I've added the ACS server to the Agent hosts, per RSA instructions, and was sure to ...

For about a week now I am setting up our new ACS 5.1. I have experienced no problems so far up until now when trying to join the ACS with the Windows AD (configuring LDAP was also no problem). I configure it using the domain name, a user and password...

Hi guys,I have been trying to join the acs 5.1 box to join the domain. I have done all the initial configs in command line such as:ip name-server x.x.x.xip domain name yyyyy.comntp serverclock set ......clock timezonenow when I try to test, I put in ...

Hello,We are in the process of renewing a certificate for our ACS server (v3.2). Is there a way to export the certificate currently in use?We don't want to lose it if we install a certificate that does not work. We are also exploring using a self-sig...

we use acs to aaa with network devices.we have 4 swich 3560 with same problem: after around 10 minutes from reboot switch, I cant login these switchs. But from these switch, i still ping ACS server. IF I reboot again, the same thing happen.Could you ...