Network Access Control

Does anyone have a step by step guide or instructions for configuring MAB on ACS 5.1?  I'm new to this version and the instructions in the user guide are as clear as mud....

Hi all,           After the ESX server on which the CS ACS server on has crased, the following services has stopped and can't be restarted: CSlog, CSDbSync, and CSAuth. I have tried manual, and auto start, but none work.Does anyone has run into this ...

I am using acs to authenticate my wlans from my 5508 controller.  I can authenticate 1st think in the morning with my two test users. I get on the network, I can go to wcs and see my usernames, I can see it in the windows event logs, etc.  Then I log...

Windows Active Directory ACS 5.1 supports all editions of: • Windows Active Directory (AD) 2000 • Windows AD 2003 • Windows AD 2008 Note ACS 5.1 does not support Windows AD Server 2008 R2. Can you guys help me to understand WHY it doesn’t support R2...

Hi,we are looking for feature present on ACS 4.x to have expiration defined per user or group. To my knowledge 5.1 has only global setting for user password expiration (password lifetime).Current setup we have on 4.x is to have password aging set for...

Is it possible to assign two IP addresses (prim/sec) to the ACS 5.1 appliance ?The reason I am asking this is that there are more than 500+ devices pointing to primary ACS 4.2 server and the rest pointing to the secondary ACS.With migration to ACS 5....

Can someone tell me why I'm getting this message. I'm beginning to think this has something to do with my device failing authorization.Show versionCatalyst 4000 L3 Switch Software (cat4000-I9S-M), Version 12.1(19)EW1, EARLY DEPLOYMENT RELEASE SOFTWAR...

Hi,I've setup tacacs for routers but after entering my credentials, it directly gets me to the priviledge (enable) mode (intead of getting me to user mode - then priviledge mode after entering the Enable password).how do i resolve this so that it get...

Hello,I configured my WLC, ACS5.0 and active directory for wireless radius atuhtnetication. When i clicked the wireless connection it prompts me to username/password and login domain name. But  when i entered those credentials i cannot login. My acs ...

Hi,I'm using tacacs(ACS 4.2) server and trying to login with my tacacs credentials but got a msg:authorization failed.....pls advise wht could be the issue and how to resolve it.Thanks

Hi,I have installed UCP on Win 2000 server and ACS 4.2 is runnning on Cisco Appliance.First login page appears correctly but after entering Username/Password following error appearsHTTP 405 - Resource not allowed