Network Access Control

HII've setup EAP-TLS wireless for testing. We've got it doing machine authentication and that part works just fine. I'm trying to setup CSACS 4.x to check the CRL published by the 2k3 CA Server but I can't seem to get the LDAP URL to be accepted by C...

My customer has many 3560 switches configured with TACACS and several have no servers under the aaa group server tacacs+ xxxxxxxx command in running config but they are there in the startup config.Some switches do not have them in either config but n...

folksi think my acs is allocating duplicate IP addresses to remote client vpn clients so i'm gonna try using a dhcp pool on another router and point the relevant group in the acs to the routerhas anyone tried this before?i'd be grateful to hear your ...

Hi,We have 4 Cisco 831 routers that we are trying to configure for wired 802.1x authentication using CSSC (Cisco Secure service client -- free version). I was wondering what version of IOS (on 831 platform) support the dot1x critical as well as Mac-a...

Hi,We are Novell Shop, we have AD running on the network in a limited environment.We have LIghtweight AP's connected to 4400's. I want to authenticate our wireless laptops to AD then MAP drives via NOVELL'S EDIRECTORY.. We authenticate to AD through ...

Are the following commands enough to configure ssh for allowing access from outside for full access to enable mode?ssh 0.0.0.0 0.0.0.0 outside cryto key generate rsa modulus 1024 aaa authentication ssh console LOCAL username (username) password (pass...

Hi,need configuration steps for my Cisco Wireless accesspoint. I want to access the device using Telnet as well as http.iam able to access through telnet using TACACS user but iam unable to access the device using http. please send the configuration ...

We have 2 ACS SE with 4.1.1.23.5 , but one them is sending a message in Reports and Actvity -> ACS service monitoring -> CSLong.csv, that goes like this:09/11/2008 11:25:47 .. Could not generate valid Password. Could not generate valid Password. 354 ...

Hi, I want my 2851 to stop allowing login attempts after 3 failed attempts and to (if possible) send an email to the network administrator about the failed login attempts. Can anyone help with this?Thanks in advance! Mitchell

I want to upgrade an ACS appliance 1113 with the version 4.0.1.44 at 4.1.4.13. the steps for the upgrade know them. But I have doubts about if I will lose data in the database, since it is very important.Thank youregards

Hi, how are you??I have problems with same ACS 4.2 with Peap authentication. Not all but same machines does not authenticate. When you go to the Fail attemps in the ACS logs you can see this mesege "Authen session time out : Challenge not provided by...