Network Access Control

I'd like to know if anyone could identify the cause for the following?We run two Secure ACS servers v4.1.3.12 (patch 2) one as primary and the other as secondary. This issue also occured in v4.1.1.23. They have no issue with replication between the...

Hello,Is there a document with ACS error codes (occuring in log) explanations? I've found only the document with ACS error codes list.Best regards,Krzysztof

folksi have an existing windows server running acs software (v3.2)it is used for cryptocard authenticationi want to migrate the service to an 1113 applicance running 4.1 - this includes the cryptodbaseany one any good documentation on how to do this?...

Hi,We've successfully upgrading ACS 3.2.1 to 3.3.3 then 4.1.All remote access works perfectly, so no trouble for the end users.Therefore we've a problem to edit downloadable ACL's.I can access to the "Downloadable IP ACLs" panel but when I click on "...

What is the similar configuration or command of "aaa accounting command <ACS_Server>" on version 7 of PIX/ASA to PIX version 6.3? I'm trying to configure aaa accounting on the pix firewall with version 6.3 using ACS server as tacacs+ server. I want t...

HelloI want to know if some GPO parameters can prevent computer authentication 802.1X ?Because we use ACS4.1 and 802.1X PEAP authentication with Vlan assignement and MACHINE authentication OnlyAnd certain PC works fine and other not And if we disconn...

I have upgraded my Cisco ACS 1113 Engines from 4.0 to 4.1 using an ACS Recovery CD provided by Cisco TAC. I am now in the process of uninstalling the 4.0 remote agent and installing the remote agent on the 4.1 Recovery CD.During installation of the R...

We bought appliances to replace ACS boxes. We had scripts that ran which would help us do some account management. My question is, is there a way to get to DOS mode on the ACS appliances? Can you run CSUTIL on them?We do not need a whole lot of sp...

Hi I am running 2 ACS servers on the SE platform running 4.0(1) Build 42. On one server everything works fine, but on the other server I get this:TCP Ports Opened49 opened2000-2003 opened1075 opened49 opened2000-2003 opened1075 openedUDP Ports Opene...

Dear I have low experiance with cisco ACSSo kindly i need help to add user to The ACS which has limited access to my network Switches ( As Show only not to change configuration )Also how to take backup for the ACS DatabaseThanks,

hi , Can anyone suggest to me any book about using ACS for pix firewalls?thanks

We have some AP1100 using 802.1x authentication with a ACS server, that is then looking up users on a windows domain, that is working fine.I would like to be able to have a specific group on the ACS that is then maped to a windows group, and when the...

I'm trying to set up authentication using a PIX 525 for some of our web servers. In preparation, I'm testing it on a PIX 515. For testing purposes, I'm not using a RADIUS or TACACS server.I've implemented the following commands:aaa-server LOCAL proto...