Network Access Control

hii have an ACS 1113 ....i have installed and configured the certificate... and trusted the CA certificate... also i configured the global authentication (enable the PEAP ,EAP-TLS)no when i try to authenticate (by the wireless) i get failed to authen...

I have tacacs ACS 3.3 I would like to deploy for large enviroment, about 500 network devices. What would be the optimal server requirements for this? and do I need to upgrade to ACS 4.1 or stay with 3.3?Thanks

Hi,I successfully upgraded our ACS SE 3.3.2 to 4.1.3.12. First, I upgraded the SE from 3.3.2 to 3.3.4. After upgrading to 3.3.4, I upgraded it immediately to 4.1.3.12. The upgrade was successful. However, the login page still displays 3.3 and the Hom...

Hi allQuick question about my NAC setup on the ACS appliance.I have create a number of Network Access Profiles from the templates that ACS provide. All is working fine but my question is in regards to the Advanced Filtering under the NAP.When I creat...

Hi,When i was reconfiguring the ip address of my ACS applicance using "SET IP" command, it failed to assign ip address, i rebooted the appliance since then whenever i try to configure ip address on it using "SET IP" address command, it gives me follo...

Hi there, I was wondering if this has happened to anyone here. I have a Windows 2000 Server running ACSv3.2 - Once every 4 months ACS will fail to authenticate all the wireless users that have Active Directory accounts. Auth-Failure code: ?External D...

What caveats can I expect when implementing 2 factor authentication, for RAS users dialing in when using RSA and ACS? Users are authenticated via Active Directory from ACS, so password expirey for them is required.I'm having trouble finding documenat...

I have disabled telnet access to my Cisco2948 and Cisco5609 (runing CATOS) but im still able to telnet, am i missing anything? here is my configset ip permit enable sshset ip permit enable snmpset ip permit 10.0.0.0 255.0.0.0 sshset ip permit 10.0.0....

Hi,Has anyone had any luch with integrating CSM With ACS4.0?I can authenticate a user but the problem is is it will only give level 1 privelige.Is there any way to force the user to go to level 15?I am using External database with Windows Authen.Than...

hi all, i'm tryin to get the certificate setup for the peap authentication for wireless clients.i installed the certificate according, enabled peap/tls authenticatiion, checked the certificate trust lists.i was able to connect to the server without t...

Hello, i wonder how could i get accounting of who get in asa n what have he done to asa. I already input :aaa accounting command <group>aaa accounting enable console <group>aaa accounting telnet console <group>And i can see who login in tacac+ accoun...

Hi,we want to upgrade ACS Solution Engine from 4.0 build 23 via 4.1 to 4.1.3.We also use Windows Remote Agent to authenticate External User Database (Windows Domain Users). Does anybody know the best way to upgrade. Should we upgrade Windows Remote A...