Network Access Control

If I need to get a third-party cert for my posture portal, how can I change the URL of the portal? Currently it redirects to the servername followed by my internal domain name. Is it possible to tie this to an external domain name?

I’m planning TrustSec for a new network based on C9K switches.If I would like to use 802.1x on access ports and dynamic classification with ISE, do I need SXP session from ISE to every access switch where dynamic classification occurs?When endUser is...

I would appear I am creating a few portals at this time. I have a client provisioning portal and now a My Device portal. So with that being said do I need to run these portals on different ports in the portal settings? 

I have a newly-installed Cisco ISE 2.4 server. I have enabled pxGrid on the node. I am able to hit the AccountCreate API, and a new username/password is returned in the response. However, the new account never appears in the UI so that I can approve ...

Hi Team,   One of my customer is having MS Azure MFA (SaaS model). They want it to use it for  1. VPN user authentication 2. Network Device administration   Wanted to know regarding the possibility to integrate ISE with Azure MFA(SaaS model) and inte...

Hello Guys, Somehow we don't have GUI access to our ACS system so I have tried to reset the same using CLI since I have CLI access using admin account.when I tried to execute the below command then it returned back as "Failed to reset password" so ca...

Hi   In a recent posting on this subject of vMotion of ISE nodes, Craig Hyps suggested to not vMotion even though it is supported.  He doesn't say what the problem is, or which versions of ISE are affected.   I suspect that we're running into an issu...

We are having issue while connecting to Wifi. We are using cisco ise for authentication. While connecting to wifi it pop up and says "thumbprint server xxxxxxxxxxxxxxx"  and when we click on connect again its connected. This issue is happening on ran...

We are having issue while connecting to Wifi. We are using cisco ise for authentication. While connecting to wifi it pop up and says "thumbprint server xxxxxxxxxxxxxxx"  and when we click on connect again its connected. This issue is happening on ran...

Hello There,We are setting up a lab, integrating QRadar and Cisco ISE with pxGrid.With this configuration we would be able to quarantine the endpoints from QRadar, which would be a manual way of doing it.I was going over some APIs to see if this coul...