93180 Management Port Configuration

[corey.burden]

Hi,

I'm trying to configure a 93180 an allow SCP.  I configured an IP 1.1.1.1/24 on the port.  On my workstation, I put 1.1.1.2/24.  I can ping the switch from the WS but I can't ping the WS from the swtich.  I added a default route to .2.   Is there anything else that is needed to allow the switch to ping the WS?

[balaji.bandi]

if WS is Windows it got default FW enabled, disabled and try,  

or try SCP see if that works.

[corey.burden · Accepted solution]

Thanks BB.  This was half of the problem.  I found the FW was turned back on after it was disabled months ago and another security app was installed on the WS. 

[balaji.bandi]

Nice to know and it was resolved we mark this as solution now - thank you.

[amikat]

Hi,

Please note that the management port (mgmt0 interface) is assigned to the management vrf by default. As such all the static/default route settings for this interface should be configured under the "vrf context management". And also the ping command should read:

"ping 1.1.1.2 vrf management".

Best regards,

Antonin