Network Management

Hi,We have a mater LMS  server and three slave server. I always see this problem on one of the slave server. DFM DCR list is always out of sync with master DCR in this server. The RME on the same server is perfectly in sync with the DCR.In DCR under ...

Hi,I hope someone can help me. I have a Problem with the Device Fault Manager 3.2.0 on a Windows standard 2008 SP2 (32 bit) Server. I can't create Notification Groups, the failure is "There are no devices in the system (in Known state). I see on the ...

we have setup sysloganalyzer in LMS 3.2 and alert us via email when certain syslog messages are received.However our email are flooded with tonnes of email. Is there any way to place a limit say 3 alerts from sysloganalyzer. The switches will still g...

Does anyone has an EEM script which can bring down the interface when it sees a ospf neighbor failurethanksAmbi

Hi.I'm after a reboot on LMS 2.6 server, the CM home page started showing the following message: "Cannot connect to ANI Server since it is down". I followed the procedures as in the thread "Ciscoworks ANI server cannot connect, Joe Clark please help"...

Hi Everyone,I am unable to generate a syslog report for most of the devices. When I checked syslog.log it appeared that these same devices are not logging there as well. Action taken are:-restart daemon manager-restart server-unsubscribe and subscrib...

Hi everyone,How can I specify time for WLANs using WLC or some other means so that they are only available during certain period of time.For example, I need Guest Wireless Network to be available only from 8am to 6pm on all WLAP1142.Thanks,

Using the GUI interface, I configured my ASA 5505 to point at a tftp server running on my desktop computer. The ASA 5505 and my desktop computer are on the same network. My desktop computer is running Windows 7 and the Solarwinds freeware tftp server...

Hello everyone,We have many Cisco network devices in our network,devices like switches,routers,firewalls,IPs ,... and for monitoring purpos we enabled logging on all of devices ,they all send syslog Debugging information to one syslog server,now i wa...

Hi all,I have a problem with the Campus Manager (version 4.1.0). After a data collection i try to se the result but get the following error:Report could not be found. I have tried to restart the ANI server, but same result. I have also tried to reini...

Dears,I have LMS 2.6 Installed with DFM 2.0.6, and it was working fine till 3 days ago. the devices in DFM Devices management are shown in Learning State and are not transferred to Known state (this has been the case for three days now).I tried the f...