Network Management

Hi,Trying to install CNA 5.4 (en) on a Windows Server 2003. But I fail because of JVM:Errors occurred during the installation.- JVM not foundJava is working and installed, at least JRE and all other Java based application are running fine.Any idea wh...

Hello all,I have installed Cisco Prime Collaboration Evaluation.  ( screen attached)  I also received license file based on PAK and MAC address via cisco lciensing web site. My question is:How could I activate Cisco Prime after adding the license fil...

Hello guys,I have got a couple of problems with Cisco Prime Infrastructure and the Nexus 7000 switches.I am becoming locked out of the Nexus (via ssh to the vty) as all (default)16 sessions are being hung by Cisco Prime Infrastructure.  I can see thi...

good morning all,my name is Ndjami yves i am a Cisco certified CCNA (ID 11877338)i am working as an assistant network administrator in a company in my country Cameroon and we want to instal a Ciscoworks LAN Management server solution 3.2 in a window...

Hello All,I apologize in advance if this in the wrong location for this post.... But I had a question about the Cisco Network Assistant.Cisco Network Assistant Version: 5.6(3)Connected Switch: Cisco Catalyst 4510R+E (WS-C4510R+E, ROM: 15.0(1r)SG5)Whe...

Hi there!I have found in some documents that Cisco Prime Infrastructure 2.0 does support IP SLA operations. So far I was able to find its ability to monitor server performance by measuring their response times, etc.What I am unable to do so far is is...

Hello,after changing the timezone and reload, ncs does not come up:ade # service NCS statusGetting the status of NCS: Health Monitor Server is running.Ftp Server is StoppedDatabase server is runningTftp Server is StoppedMatlab Server is StoppedNMS Se...

Hi Folks, I did a prime upgrade to 2.0 from the patch PI_1_3_0_20-Update.4-16.tar.gz and it failed.... and i cannot do ncs start... But i guess i dont have the backup as well... but its asking to restore... What am thinking is am i supposed to restor...

Hi All,We are using LMS 3.0, we have installed new 6506-E replaced with 3750. Everyting is working fine. but I am not abvle to open Chassic View of new switch. It is showing some old data. is it because IP address is same?SNMP configure is as below:s...