Cisco Works Incorrect Community name

[sebastian.wiegand]

Hi all,

I use CW RME 3.5, CS2.2. Now there are two C3550-24, that respond for a polling with an Incorrect Community Name Trap. If I try to access these switches via CW it works... I can make my changes and apply them via snmp.

I compared a hardware (and software) report of these switches to other C3550-24 that works fine but all thats different seems to be the chassis version (and of course the hostname and IP ;-))...

any ideas?

Regards,

Sebastian

[nhabib]

Are the Incorrect Community Name Traps sent when User Tracking discovery is run?

[sebastian.wiegand]

Hi nhabib,

yes i think so.

Regards,

Sebastian

[nhabib]

Hello Sebastian,

I suspect this could be related to bug id CSCea42364 somehow.

You might want to stop the CiscoWorks Daemon Manager, and add the following line to your ANIServer.properties:

UTGetVlansWithUserPorts=1

Re-start the CiscoWorks Daemon Manager and see if the issue is resolved.

[sebastian.wiegand]

i will try it out if u can tell me whre to find ANIServer.properties.... Sorry i'm new with CW.

Regards,

Sebastian

[nhabib]

On Windows it would be in CSCOpx\campus\etc\cwsi

On Solaris it would be in /opt/CSCOpx/campus/etc/cwsi

Make sure you make a backup of the original first

[sebastian.wiegand]

Hi,

I found it but the Param is already set. Any other suggestions?

Regards,

Sebastian

[andrzej.kolman]

Hi Sebastian,

Did You resolve problem with incorrect community traps generated while CW2K runs user tracking??

Regards

Andrzej