Invalid commands in 1941 ?

[bern46]

Hello,

I'm doing some tests with a 1941 router and setting up dhcp.

While inside a dhcp pool I get an error with the lease command:

router(config)#ip dhcp pool NET1

router(dhcp-config)#lease 10

^

% Invalid input detected at '^' marker.

Also the clear ip dhcp binding it's giving an error as if it was invalid.

Both seen in the 1941 documentation: https://www.manualslib.com/manual/1198349/Cisco-1941w.html?page=343#manual

This is only for some tests, at the end I think I'll have DHCP in a dedicated server.

Thanks and regards.

[Kasun Bandara]

@bern46 

are you using real IOS or packet tracer device?

[bern46]

Packet tracer !

[Kasun Bandara · Accepted solution]

@bern46 

unfortunately packet tracer not support this command.

[bern46]

How do you exactly know which commands are valid in PKT and which ones not ? Just by experience ... ? 

Thanks a lot !

[balaji.bandi · Accepted solution]

no support i guess as per the post :

https://learningnetwork.cisco.com/s/question/0D53i00000Kt4RRCAZ/cannot-set-lease-time