01-19-2023 02:18 AM
Hi All
I have a SG300-28PP 28-Port Gigabit PoE+ switch but the PoE+ is not working on it.
Does the PoE+ need to be enabled on selected ports? Or is it automatic.
01-19-2023 03:07 AM
Make sure you go install the latest firmware 1.4.7.X and check
01-20-2023 05:29 AM
Thanks for your reply.
I upgraded the firmware to the latest version but still having the same problem. It's an IP camera that requires PoE+. Any other ideas?
01-20-2023 07:24 AM - edited 01-20-2023 07:25 AM
what camera is this ? what interface presentation 10/100 or gig ?
can you post show power inline consumption , also try different ports and same results.
Also look some settings :
also check some notes :
N OTE The switch can deliver a maximum of 15.4 Watts to any 10/100 or
Gigabit PoE port. The 24MP, 28MP, 52P and 52MP models of the switch
can deliver a maximum of 30 Watts to any PoE port.
https://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbms/sf30x_sg30x/quick_start/78-19252-01.pdf
01-19-2023 03:55 AM
its automatic. no need to do any special configurations.
01-20-2023 05:30 AM
Thanks for your reply. Unfortunately PoE+ doesn't seem to be working on it. Its for an IP camera that requires it but no luck.
01-21-2023 12:02 AM
Hello,
you might want to toggle the PoE Properties and set the maximum power limit to the highest value (see page 219 of the attached admin guide).
Also, what brand/type/model is the IP Camera ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide