04-03-2021 11:48 AM
I have defined VTY 0 15 timeout, my SSH session is on MGMT (out of band) interface and vty timeout is not working. How do I enable it for MGMT as well?
04-03-2021 12:50 PM - edited 04-03-2021 12:50 PM
Hey,
In general configuration use:
ip ssh time-out XXX
instead of XXX put time in seconds, you can additionally use:
ip ssh authentication-retries 5
to limit tries to 5 or any other number that you like.
04-03-2021 08:49 PM - edited 04-03-2021 08:54 PM
I have the following commands but no ssh session never gets disconnected.
SW01#show running-config | include ssh
ip ssh maxstartups 10
ip ssh time-out 30
ip ssh authentication-retries 5
ip ssh logging events
ip ssh version 2
-----
Also defined following command on MGMT but no effect.
SW01(config-if)#timeout absolute 60
transport input ssh
04-05-2021 02:06 AM
Hello,
not sure if I missed something, but how did you configure the VTY timeout ?
line vty 0 4
exec-timeout 1
will disconnect your VTY session after 1 minute of inactivity (regardless of whether you are connected through SSH or Telnet)...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide