I was curious if there is a section in firesight where it could be programmed to block hosts like the CISCO IPS host blocks section? Kind of like the list of hosts blocked for triggering signatures. Trying to translate this into the new product. Also...
Forum Posts
Hello, We've an ASA running on a FPR-2110 with a single Site-To-Site VPN. We need to create redundancy by adding another ASA/FPR-2110. What's the best way to accomplish this? Thanks in advance, ~zK
Resolved! disabling TLSv1.0 on ASA5505
I have an ASA5505 that is failing a PCI DSS Scan because it uses TLS1.0 Is there any way to disable this protocol?
Hello I have been asked to get more info on these syslog events and I don't have the slightest clue. I have not dealt with FirePower at all. Any assistance/direction would be greatly appreciated! Dec 19 2018 19:33:07 XXXXXIPS1 snort[18738]: [1873...
Is there a way to perform multiple filters to a show command in the Cisco ASA IOS (8.4 and above)? Please give an example if there is. I tried:show access-list | include 10.15.221.22 | exclude 1270but that does not work.
Hello Sorry if this is the wrong place to post. Please correct me if so. I have been tasked with gathering event logs from a Cisco FirePower 8120. I don't know the first thing about the device. Could someone tell me how I would go about extractin...
Hi , I'm just wondering if we can manually update the lastest VDB version for this management center(version 5.3.1)Thanks everyone.
Resolved! ASA: rommon
Dear all I have issue with asa5506. i try to boot image from rommon but rommon showed error rommon 10 > boot disk1:/asa951-lfbff-k8.spaLocated 'asa951-lfbff-k8.spa' @ cluster 3.######################################################################...
Hello everyone! I've got a Firepower v6.2 and I'm trying to configure ACLs including filtering by users. I managed to integrate the Firepower with Active Directory, that is I can download users and groups succesfully. I've already configured an Iden...
Dear All I have issue with ssh from asa 5525. I can't to connect my asa via SSH from other network 172.16.1.1. But I can to connect my asa from Lan Network 172.30.1.1 Could you help me How i can to configure my Asa for connect to asa from other netw...
Resolved! Replace ASA firewall with FTD design.
Currently, the firewall is setup with 3 interfaces (internet, inside and dmz). The DMZ and Inside using subinterfaces on a port channel to respective vrfs for dmz and inside network. Now this will be replace with FTD next year and we desire to use FT...
Resolved! FWSM idle connection timeout issues
The service policy appied to set the idle connection timeout does not apply for a particular traffic destined for SQL net connections . However any other TCP ports are identified . Does that mean that Sql Net connections idle timeout can be altered o...
Hi all, I had an FTD (2110) connected to an FMC but need to join it to a different FMC. So I broke it's HA and then deleted it from the FMC. I still have full SSH access to the FTD unit but am looking to get webgui access to it once again - or ...
Description the issue:I have two ASAs which were configured Active / Standby Fail-over. The issue is one of three servers that reside under this 10.71.0.0/24 subnet cannot reach the primary gateway 10.71.0.1. However, it is able to reach the standby...
Hey all, We have recently upgraded from pfsense to Cisco ASA. On the pfsense were were rate limiting users connections to 7mb/7mb for download upload limit to the internet. I have tried applying a policy-map, however it stops the bandwidth from e...
