Dears, whenever my Pri-ASA is active with SFR the access rule are hitting appropriately , whenever the ASA failover occurs i can see the some access rules on the secondary ASA SFR are hitting to the appropriate and most of them to the default rule i....
Hi all, I'm looking to see if this configuration is even possible with the ASA, or at all, but I'm not really sure what this type of setup would be called. I endlessly searched this forum for a similar request, but I haven't been able to find one a...
Hi, I need to upgrade ASA5585-SSP-10 to new version, please let me know what is memory requirement for upgrading from 8.2 to 9.9 version. Below are detail of device Cisco Adaptive Security Appliance Software Version 8.2(4) Hardware: ASA5585...
Issue statement first: We are not receiving certain log fields on the Qradar as it appears on the FMC event viewer console. 'Firewall policy', 'rule name', whether Allow or Block etc such fields are not received from FMC. Cisco FMC is integrated with...
I have a firepower sensor in a ASA 5585X that I upgraded from 6.2.3 to 6.2.3.2 from my FMC 1500 Upon completion, I got a message saying the data plane interfaces were not receiving traffic. I SSH'd into the sensor and saw that this was indeed the c...
We have a pair of Cisco 5525-X series hardware appliances configured as a HA active/standby pair. The 1st ASA (active) we access via SSH and monitor using a specific IP address e.g. 192.168.0.1 The 2nd ASA (stby) we access via SSH and monitor using...
Hi I have deployed ASA on Firepower 4100 series Chassis, configured one of the data interface as a management interface with an IP address. I have connected a laptop directly to the management interface try to ping - unable to ping. Global policy is ...
Hi guys, Just wondering, if I configure like DNS in the admin-context, does it apply also to my 2 other user context? thanks
Hello all, after upgrading to version 6.2.2 we face the following error security intelligence URL: memcap exceeded also same error exist in 6.2.2.1 I saw similar bug but on FTD, we are not using FTD we are using one virtual firepower manag...
Hi everyone, I was curious if there was a way to connect an Aircard\Hotspot to the 5506-X ASA and get internet from it, I was looking at the installation guide and I see that there is a way to connect a usb but it only mentions it as a usb drive. Can...
I am attempting to upgrade the software on my sensors, and I continue to receive "update install failed" errors on them. I ran into another thread suggesting to "re-apply" the existing health policy, and then try again. Not only did that not work, no...
Hi All, Maybe i'm asking a stupid question, but i'm used to ASA 9.x. On ASA 9.x you can enter the command "show route X.X.X.X" and it will show you exactly what route it it will take.On ASA 8.2 (or maybe it's complete 8.x) you need to specify the int...
Hi Guys, I have added near to the bottom of our NAT config a DNAT rules: nat (outside,inside) after-auto 32 source static any any destination static ext_inet_DNAT_Public_IP DNAT_PrivateIP unidirectional description Dnat Rule for monitoring After ...
Hi, I appreciate if any can help me. I have a Cisco 5512X ASA, and i have IPS licence (siftware module) but Cisco suspend firm generation for IPS. For compilance i need active an updated IPS and Attack Firms. Did some form of upgrade IPS to new ...
Hello , I am a Master degree student in Administration And Security Of Systems And Networks at the Higher Institut Of Computer Science In Mahdia - Tunisia. I Created an Account at you platforme, and I was trying to download " Cisco Adaptive Securit...
