Resolved! FP 2120 Default Image
I would like to find out what is the default image that the FP2120 comes with when its purchased.
Forum Posts
Hello, we're looking to implement an FTDv as an edge device for our Azure network. Currently our on-prem consists of a physical ASA and an outsourced IPS device (iSensor by Dell Secureworks) that sits in front of the ASA. My question is, are the IPS,...
Hey Guys, I am a complete newbie to Cisco so excuse my ignorance,I have just setup the device and want the Outside interface to receive traffic from my home Netgear broadband router and then pass it through to inside interface.How do i go about doi...
In ASA firewall is there a provision to define ACL rules based on Application ID apart from source/destination IP Address? In other firewalls I have seen access rules based on service/application GUID along with source/destination IP.
If I enable dce/rpc inspection, can I have active directory over firewalls without allowing dynamic ports? I have 2012 R2 domain controllers in firewall segment and AD clients in a different subnet.
Hi,Is there a way to configure multiple access-group on same interface on PIX?such as:access-group ACL-IN-1 in interface outsideaccess-group ACL-IN-2 in interface outside TIA
Good morning everybody,After a lot of time passed on the internet to try to resolve my problem, I have decided to post my problem here and I hope that you can help me.I have a FWSM which doesn't start. After analyze and tests, I think that the CF is ...
Hello all, Something strange happened on our ASA recently. Maximum concurrent connection was reached and new connections were being dropped which caused service failure. Just hours before this, netflow was configured on the box and it is now a su...
Hello, I am using the VM fore FireSIGHT, version as below: Cisco Fire Linux OS v6.1.0 (build 37) Cisco Firepower Management Center for VMware 6.1.0.6 (build 85) ASA versions: Cisco Adaptive Security Appliance Software Version 9.6(4)3 Device Manag...
we have two ASA 5550 firewalls at our datacenter in active-standby mode. But when we switch off active firewall, standby firewall doesnt takeover. To resolve outage we have to reboot standby firewall so that primary firewall takes over. hereby attac...
I am trouble shooting an issue where I see a lot of return traffic from web browsing getting denied. I am running an software version 9.6(4).6 with a Firepower module on board. I originally though it was due to closed (torndown) connections but d...
Hello,I just picked up 2x Cisco ASA 5515-X firewalls. At the time I thought they were identical, but there are some differences. One model has V01 on the sticker, in sh ver it is showing with 4GB Flash and running ASA 8.6(1)2. The second model is V04...
HiOn FMCv 6.2.2 and FTD 2110 ver.6.2.2, the cluster displays both FWs as active when it's active backup if I check the FTD CLI.There must be a bug in this version.Anyone have experienced something similar?Thanks
I have a HP printer on my Office VLAN ( 192.168.160.190) that I would like to create a virtual IP on my House VLAN at 192.168.150.190, to allow printing from the less secure House network to Office network. I need assistance with setting up the netw...
