Hi ,please I totaly confused about the EOL date of NGFW ASA5545-X series would you please confrim the date of EOS ,EOL it is not clear in cisco site
Forum Posts
Hi cisco community,I will admit i was not sure rather to put this under security or switching. Recently, my company has decided to have a outside auditor come in whom uses tenable. One of these scans has hit two of our switches, a 9300 and 3560CX ha...
Hi All,I am having bizarre issues that occurs time to time when I am doing upgrades on FTD pair in HA. I am managing them using FDM while await CDO licenses.My typical setup consist of 2x FTD's (FTD1140 and FTD2120 is where issues has been observed),...
Can anyone share either a config or a link to a working Cascading Context example?
Resolved! FPR-3100 ACL Elements
What is the recommended ACL elements count for each of the FPR-3100 series firewalls?
I'm trying to automate some deployments of FTD firewalls (on 7.0.0) for my company (It's the FP 1010 if it matters, and we're using FDM).Due to the way we process them, the firewall get's the admin password changed (and the EULA accepted) before it's...
Dear all, Any can confirm me about the combability issue on using 10G base T module in Cisco firewall 3130 in 8X10G fiber slot. Thanks in advance Shibly
I am considering purchasing an FTDv5 license for my FTDv installation. However, I am unsure whether the license provides a bandwidth of 100 Mbps for both incoming and outgoing traffic simultaneously.For example, if I wish to transmit outgoing traffic...
This is a new setup and client is prompting for primary/secondary usernames and passwords correctly, but my login attempts are failing. I can see that both RADIUS servers are returning Access-Accept, but the AnyConnect client displays ‘Login error’Wh...
I have an ASA which, for one subnet only, will not pass traffic. Configuration is consistent between a number of working interfaces with only the IP network and VLAN being different. Same physical interface with only sub-interfaces and IP ranges be...
Resolved! C4500-16 and hmac-sha1
Hello,We had a security report come back to us detailing that we have a test switch with a weak key exchange algorithm. After checking the switch I found that it is using hmac-sha1. I noticed that the firmware version is on 15.0 and I found that sha2...
By some reason, our company client FP 2110 is in Rommon mode . I have loaded the ASA in the USB stick and trying to boot, however, constantly getting the below error. Can someone guide me what needs to be done now ? %ERROR - Failed to get Act 2 cooki...
Resolved! EngineID for FMC
Hi, I am currently configuring SNMPv3 on FMC version 7.4.2. Server Team asked me for the EngineID which need to be matched in the SNMP Server. I did some search, there seems to be default EngineID generated when SNMP trap or SNMP server is configured...
Hello,there is a requirement to enable logs on TCP 6514 port with TLS. From some articles we found the command but those are not available in current version of IOS. Switch model is 2960-X and current IOS is 15.2, can any one confirm that the require...
I was unable to use the migration tool so had to configure manually. Now I am in a situation where I only have one tunnel group showing on the anyconnect drop down as seen below.I should have three other tunnel groups showing here. How do I configure...
