With EEM I am seeing that I can create events for backups. Is there a way to have the backup with the hostname and time stamp like archive with Routers and Switches?
With EEM I am seeing that I can create events for backups. Is there a way to have the backup with the hostname and time stamp like archive with Routers and Switches?
Can you help me to block facebook on office time ( 9.00 am - 5.00 PM) on asa. I tried with time based ACL. But dificulty is facebook has lot of public IPs. from ACL can block one IP or range only. can you help me, please ?
Good afternoon.In order to increase fault tolerance, it is necessary to combine 2 * ASA-5525 into the cluster.On the one hand stack of switches 3850 (office), on the other Microtik (Internet).I plan:CCL - through the switch a separate etherchannel, f...
ASA Firepower software module stops forwarding traffic and i can't see anything in any logsThat could cause this problem.If we redeploy policy's without any changes it starts work again !!! Installed ASA Firepower version/filesasasfr-sys-6.2.0-362.pk...
What is everyones thoughts and take on exposing applicaiton/web servers to outside users? I have always believed that any server accessed from outside the internal network via the internet or any other situation should be in a DMZ. I know some people...
Hi all, I have a question in regards to the Firepower upgrade process. I upgraded my Firepower appliance 9300 FXOS image to 2.2(2.17). I have one FTD, running 6.2.0.362; this FTD came back up fine after FXOS image upgrade. However, I have another FT...
i need to know how many logs i can store on the firesight ?
Hi, Could someone please suggest me, the configuration to monitor Latency thersholds to our VoIP destination using SLA monitors, for ISP failover. I am using ASA - 5516x with two ISP providers connected on Firewall. We are routing default route on I...
Installed an ASA-5506x on a client site - when a vendor sends the email using TLS they get < #5.0.0 smtp; 5.4.7 - Delivery expired (message too old) 'TLS Unavailable' (delivery attempts: 0)>'. Disabled the esmtp fixup protocol with no sucess. Tried a...
Hi Cisco Support, May we request for your assistance as we are having this syslog error regarding IP Spoof. What could be needs to be check? Please see attached screenshot for your review. Thanks!
Dear ExpertI hava an issue with cisco ASA. In my ASA have three zone. like Inside, dmz, Outside. All DMZ server ip NATtranslation configure on Router which is connect with ASA outside zone. So when i wnat to ping from inside user pc to DMZ server pub...
Hi We are trying to allow UDP broadcast 9 packets via the firewall. Basically WOL packets needs to be send from one network segment to another. And we are also aware '' In routed firewall mode, broadcast and multicast traffic is blocked even if you a...
hi all,i got an ASA5525-X active/standby pair and would like to activate anyconnect RA VPN.i already added license the premium license (750 peers) and had doubts on the standby device.my search found this link and mentioned only primary headend VPN d...
Hello, Here is diagram: R1 ---- ASA(Outside) ---- R2ASA can ping R1 and R2 respectively, and both routers can ping ASA. But R1 cannot ping R2. Vlan1 connect to R1 and Vlan2 connect to R2. Anyone can help find something missing: Below is relevant conf...
here is what i know so far. since last week. the time attendance device cant be connected via remotely. remotely meaning via a VM containing the time attendance software. because it only runs on windows 7.prior to the problem happening. the device wo...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
10-23-2025 07:14 AM | ||
10-21-2025 08:39 AM | ||
10-20-2025 12:53 PM | ||
10-08-2025 02:11 AM | ||
09-26-2025 12:33 AM |
User | Count |
---|---|
18 | |
6 | |
2 | |
1 | |
1 |