Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hello, I have an access with ASDM problem on my Cisco ASA.  The configuration using ASDM was working well before. But now when I attempt to connect with ASDM, I get: Unable to launch device manager from 172.28.0.250 There is the configuration for...

Resolved! ASA custom access

Hi, Can ASA support custom access for administrators:I Wan't it to gave access for one administrator to do unlock users for VPN access not to have example to do any other configuration ?? Thanks, Gezim

I'll try to make this as least complicated as possible. Scenario: Mirror all traffic being sent to and from vlan x on a Nexus 5672 to an interface that is directly connected to an ASA 5525x. Purpose: To filter and inspect traffic on the ASA FirePOWE...

Hi, I wonderr if anyone can help -  I recently installed an FMCv and associated a 5515X firewall running firepower services with it. I though I had licensed the 5515X, as I went through the procedure, genrated the license file, based on the FMC key,...

I just ran a portscan on my asa firewall and noticed that the ports listed below are open on my outside interface. My problem is that I am not using any of these ports and have not firewall rules permitting them. Any ideas on how to close them? 2000...

tech_king by Level 1
  • 3967 Views
  • 4 replies
  • 0 Helpful votes

I'm making a CISCO router get the time from country specific ntp.org's servers (GMT+2). It functions correctly but does not adjust to daily savings (GMT+3). Not a big problem here. I don't want that anyway. Then, I synced the ASA firewall and Cat swi...

So I have run into an issue I have never seen before and I thought I would share the issue with a group. We installed a new ASA 5505 at a site using 3 interfaces: E0/0 = WAN E0/1 = 192.168.1.1 E0/2 = 192.168.2.1 We setup interVLAN routing between E0...

Review Cisco Networking for a $25 gift card